Important! Please follow these instructions. This kit may be different from the one specified in instruction booklet. | 07/31/2006 |
COMBINATION 8X8 and 10X8 FLOOR KIT
This floor kit will build either the 10’ wide or 8’ wide x 7’
FOR MARCO SERIES, SOLAR SHED AND MWP IMPERIAL ONLY
This floor kit is for 10’ x 7’
- B E F O R E Y O U B E G I N -
First...
Read these instructions thoroughly before you begin assembly. Assembly is easiest if you follow the steps in the order shown.
Lumber is graded from only one side. Check the part for the most attractive face and make sure to face it to the outside.
Check all parts
Compare parts you have to the list on page 2. If a part is missing, circle the part in question in the parts list and call us
■Tools required
❑Hammer
❑Level
❑Pencil
❑Tape Measure
■Optional tools
❑Chalk Line
❑Square
❑Nail Pouch
❑Saw
Assistance required
We recommend that you assemble this floor on level ground in the location it will be used. Assistance is necessary to handle, fit, and secure some components. Two people maybe needed for some steps.
Squareness is very Important!
Keeping all 90° corners and 90° perpendiculars square throughout the assembly of this floor kit will make each succeeding step easier and is necessary to assure that all components fit together properly.
Check local zoning
Before starting construction, check with your local building code official for any required permits, variances, etc.
Check floor kit size
Before starting construction on your floor, make sure that you check in the instruction manual to ensure that you are building the correct size floor kit for your building.
Always wear
8x8
See pages 2-3-4
10x8
See pages
#16628
1