Husky 16628 8X8 OPTIONAL SHELF INSTRUCTIONS, Parts needed to cut, C1 - 2x4x89-1/2Floor Joist

8X8 OPTIONAL SHELF INSTRUCTIONS

Parts needed to cut:

B1 - 23-7/8x92-5/8x5/8" Floor Panel

C1 - 2x4x89-1/2" Floor Joist

E2 - 2x4x48" Bond Boards

-2" and 3" Nails

Cut

Cut

A

CB

(1) - 89-1/2" Board C cut down to 88"

Cut

(1) - 23-7/8x92-5/8" Panel B cut down to 23-7/8x89-1/2"

E

24-11/16"

23-3/16"

(2)- 48" Board E cut down to 2 pieces of 24-11/16 and 23-3/16"

SHELF PARTS TO CUT:

A:Cut the 89-1/2” Board C down to 88”. Cut both 48” boards E at 24-11/16” leaving 23-3/16”. Finally cut the 23-7/8x 92-5/8” panel B to 89-1/2”.

B

24-11/16"

3" Nails

	23-3/16"	24-11/16"
23-3/16"
	88"
	32"	3" Nails
		Center
28"
	Center	of Stud

of Stud

SHELF ASSEMBLY:

	Rear Wall
C	3" Nails
	3" Nails
	3" Nails
	3" Nails

2" Nails

B:Mark the 88” Board as shown at 28” then another 32”. Attach the 23-3/16” with (2) 3” nails as shown. Attach the 24-11/16” boards to each end of the 88” board with (2) 3” nails.

SHELF INSTALLATION:

C:Install the shelf frame resting on the horizonal Back Wall Brace. Attach middle braces with 3” nails as shown. Level front of frame and nail into Side Wall Studs or Top Plate depending on your building model with 3” nails as shown.

Rear Wall

2" Nails

D

23-7/8x89-1/2" Panel

SHELF PANEL INSTALLATION:

D:Center the 23-7/8x89-1/2” panel on the shelf frame and attach with 2” nails as shown.

4