English
PROBLEM OR CONCERN | POSSIBLE CAUSE | SOLUTION | |
|
|
| |
No water coming out of | Gun/Hose Assembly is defec- | Attach the Gun/Hose to the front of the unit with no | |
Wand | tive | wand attached to the Gun. Squeeze the trigger of | |
|
| the gun to ensure that water comes out of the front | |
|
| of the Gun at a rate equal to the Garden Hose. If no | |
|
| water comes out of the Gun, remove the gun and | |
|
| the hose to ensure that water flows out of the pump. | |
|
| If it does, the gun will need to be replaced. Contact | |
|
| us at customerservice@huskypowerwash | |
|
| er.com or order a replacement directly online at | |
|
| www.huskypowerwasher.com. | |
Trigger will not move | Gun Safety Lock in engaged | Release Safety Lock as instructed in Manual. | |
|
|
| |
Unit will not start | Unit is not turned on | Press ON/OFF Switch into ON position. | |
Note: Unit will only start when |
|
| |
Loose or disconnected Plug | Reconnect Plug. | ||
trigger is depressed. |
|
| |
Defective GFCI Plug | Perform GFCI reset procedure as instructed in | ||
| |||
Unit stops while operating |
| Section 2.0. If the Plug does not reset it will | |
|
| need to be replaced. Contact us at custome | |
|
| rservice@huskypowerwasher.com or | |
|
| order a replacement directly online at www. | |
|
| huskypowerwasher.com. | |
| Extension Cord length or gauge | Use proper Extension Cord as instructed in section | |
| incorrect | 2.0. | |
| Gun trigger not operating pro- | Contact us at customerservice@huskypow | |
| perly | erwasher.com or order a replacement directly | |
|
| online at www.huskypowerwasher.com. | |
| Defective Gun | Remove the Gun and Hose assembly from the front | |
|
| of the unit. Aim water stream away from electric | |
|
| source and switch the unit into the ON position. | |
|
| If the unit starts and water comes out of the front, | |
|
| the Gun may need to be replaced. Contact us at | |
|
| customerservice@huskypowerwasher. | |
|
| com or order a replacement directly online at | |
|
| www.huskypowerwasher.com. | |
| Tripped Pressure washer Ther- | Allow to cool and restart unit. | |
| mal Switch |
| |
| Defective ON/OFF Switch | Contact us at customerservice@huskypow | |
|
| erwasher.com or order a replacement directly | |
|
| online at www.huskypowerwasher.com. | |
Unit will not stop when trig- | Screen filter is clogged | Clean the Screen filter as instructed in the sec- | |
ger is released |
| tion 6.4. | |
| Garden Hose is kinked or | Make sure the Garden Hose is laid out flat and | |
| leaking water | there are no kinks in it. The hose should not be | |
|
| wrapped on a storage wheel. Make sure the | |
|
| faucet is open all the way and there is a full | |
|
| volume of water reaching the unit. | |
| Wand is malfunctioning | Test both wands to ensure that one is not mal- | |
|
| functioning. | |
| Gun is not operating properly | Remove Wand from the Gun and squeeze trigger to | |
|
| ensure that the water is coming out of the front of the | |
|
| Gun at a rate equal to the Garden Hose. |
20
