English
5.0OPERATING INSTRUCTIONS
WARNING: Risk of Injury. Do not direct discharge stream at anyone.
WARNING
5.1START-UP PROCEDURE
1.Make sure water supply is connected and turned on. (Do not use hot water).
2.Make sure the unit is plugged in.
3.Release gun safety if locked. (Fig. 17) Shown on page 11.
4.Remove any dirt or foreign matter from the gun outlet and the male connector of the wand.
5.Insert the wand into the gun’s quick connect coupling by pushing firmly and twisting wand ¼ of a turn to lock into place. (Fig. 13) Shown on page 10.
6.To allow air to escape from the hose, squeeze trigger on the gun until there is a steady stream of water coming from the nozzle.
Fig. 18 |
Fig. 20 |
WARNING: If the wand is not securely locked into place, it could be ejected under high pressure when operating
WARNING the gun.
7.Press power switch on the pressure washer to the “ON” position. (Fig.18)
8.Squeeze the gun trigger to start the pressure washer.
WARNING: Make sure the wand is
pointed in a safe direction when starting
the pressure washer. Do not point at face WARNING or feet as serious injury could result.
NOTE: Make sure wand is locked. (see fig.13) As shown on page 10.
5.2VARIABLE SPRAY NOZZLE
The variable spray nozzle can adjust spray from fan to pencil point. The spray is adjusted by turning the nozzle.
Fig. 19 |
Fig. 21 |
14
