24 – English
MAINTENANCE
12
3
1
2
8
9
Fitting the cutting unit
1. Position the Rider on a flat surface and apply
the parking brake, see page 10. Check that the
lever for adjusting the cutting height is at the
lowest setting.
Make sure the support wheels are fitted to the
cutting unit (1).
2. Grasp the handle at the front (BioClip 90) or
hold the frame of the cutting unit (2) and slide
the unit underneath the rider mower, making
sure that the tongue on the cutting unit (3)
engages correctly.
3. Insert the bolt and secure it with a locking pin.
4. Press down the frame and insert the pin. Fit the
drive belt around the drive wheels of the cutting
unit.
5. Hook up the height adjustment strut.
6. Fit the front cover.
7. Fit the spring that tensions the tensioning
pulley, see page 27.
Installing BioClip 90
In order to install BioClip 90 the drive belt support
wheel must first be removed.
1. Disengage the spring from the tensioning wheel.
3. Remove the locking pin (1) that is located next
to the support wheel.
4. Fit the cutting unit as instructed on the previous
page.