Husqvarna 16 H Lubrication, General lubrication, Checking the tyre pressure

1 44

32 – English

Lubrication

The following two lubrication points should be

regularly lubricated with high quality graphite

grease.

With daily use lubrication should be conducted

twice a week.

All joints and bearings are lubricated on manufac-

ture with molybdenum sulphide grease. Re-grease

with same type of grease. Lubricate the steering

and control wires with engine oil.

The machine should be lubricated regularly, and

twice a week when used daily.

The tyre pressure should be 60 kPa (0.6 kp/cm2) all

round.

To improve driving the pressure on the rear tyres

can be reduced to 40 kPa (0.4 kp/cm2).

The maximum tyre pressure is 100 kPa (1.0 kp/cm2).

IMPORTANT INFORMATION

Different tyre pressures on the front tyres

will result in the blades cutting the grass

at different heights.

MAINTENANCE

Contents

Main Page Operators Manual for Rider 16 H CONTENTS 2 !! !! ! N R EXPLANATION OF SYMBOLS 1. Safety rules for USA !! III. Children IV. Service General use: Driving on slopes Children Maintenance Page Presentation Location of the controls 4 65 789B 1011 9A 3 13 2 1 12 Throttle and Choke lever Parking brake Speed limiter Cutting unit Lift lever for cutting unit Fuelling Seat Lever for adjustment of cutting height Starting the engine Page Driving the machine Cutting tips ! Stopping the engine MAX 15 Release lever ! Maintenance schedule Page Check the engines oil level Checking of the fuel pumps air filter Check the engines cooling air intake Checking and adjustment of the steering wires tightened Adjusting the brake FULL Check the transmissions oil level only Check the level of the battery acid Check the safety system Replacing the air filter Fitting the cutting unit Installing BioClip 90 Checking and adjustment of the cutting units ground pressure Checking the cutting units parallelism Adjusting the parallelism of the cutting unit Removing the cutting unit Replacing the cutting unit belts Page Service position for cutting unit Placing in service position P Page Page Lubrication General lubrication Checking the tyre pressure Checking the blades Changing the oil Checking and adjustment of the throttle wire Replacement of the fuel filter TROUBLE SHOOTING SCHEDULE Problem Procedure Winter storage STORAGE Service TECHNICAL DATA EU declaration of conformity