Husqvarna 16 H Stopping the engine, Release lever

English – 17

DRIVING

Stopping the engine

Preferably allow the engine to idle for a minute to

obtain normal working temperature before stopping

it if it has been working hard.

1. Lift up the cutting unit by pulling the lever back to

the end position.

2. Pull back the throttle control and turn the ignition

key to the STOP position.

STOP START

In order to move the machine when the engine is

switched off the release lever must be pressed

down and forwards.

WARNING!

Never drive the machine on ground

with a slope of more than 15°. Mow

slopes upwards and downwards,

never across. Avoid sudden changes

in direction.

Contents

Main Page Operators Manual for Rider 16 H CONTENTS 2 !! !! ! N R EXPLANATION OF SYMBOLS 1. Safety rules for USA !! III. Children IV. Service General use: Driving on slopes Children Maintenance Page Presentation Location of the controls 4 65 789B 1011 9A 3 13 2 1 12 Throttle and Choke lever Parking brake Speed limiter Cutting unit Lift lever for cutting unit Fuelling Seat Lever for adjustment of cutting height Starting the engine Page Driving the machine Cutting tips ! Stopping the engine MAX 15 Release lever ! Maintenance schedule Page Check the engines oil level Checking of the fuel pumps air filter Check the engines cooling air intake Checking and adjustment of the steering wires tightened Adjusting the brake FULL Check the transmissions oil level only Check the level of the battery acid Check the safety system Replacing the air filter Fitting the cutting unit Installing BioClip 90 Checking and adjustment of the cutting units ground pressure Checking the cutting units parallelism Adjusting the parallelism of the cutting unit Removing the cutting unit Replacing the cutting unit belts Page Service position for cutting unit Placing in service position P Page Page Lubrication General lubrication Checking the tyre pressure Checking the blades Changing the oil Checking and adjustment of the throttle wire Replacement of the fuel filter TROUBLE SHOOTING SCHEDULE Problem Procedure Winter storage STORAGE Service TECHNICAL DATA EU declaration of conformity