Husqvarna 16 H - page 33

English – 31

MAINTENANCE

Restoring from service position

To restore the machine from the service position,

reverse the sequence “Placing in Service position“.

7. Lift off the drive belt (1). Then pull out the pin

(2).

Take care not to get your hand trapped.

8. Pull the frame forwards and insert the pin.

9. Grasp the front edge of the cutting unit, pull out

and raise into the service position.

Contents

Main Page Operators Manual for Rider 16 H CONTENTS 2 !! !! ! N R EXPLANATION OF SYMBOLS 1. Safety rules for USA !! III. Children IV. Service General use: Driving on slopes Children Maintenance Page Presentation Location of the controls 4 65 789B 1011 9A 3 13 2 1 12 Throttle and Choke lever Parking brake Speed limiter Cutting unit Lift lever for cutting unit Fuelling Seat Lever for adjustment of cutting height Starting the engine Page Driving the machine Cutting tips ! Stopping the engine MAX 15 Release lever ! Maintenance schedule Page Check the engines oil level Checking of the fuel pumps air filter Check the engines cooling air intake Checking and adjustment of the steering wires tightened Adjusting the brake FULL Check the transmissions oil level only Check the level of the battery acid Check the safety system Replacing the air filter Fitting the cutting unit Installing BioClip 90 Checking and adjustment of the cutting units ground pressure Checking the cutting units parallelism Adjusting the parallelism of the cutting unit Removing the cutting unit Replacing the cutting unit belts Page Service position for cutting unit Placing in service position P Page Page Lubrication General lubrication Checking the tyre pressure Checking the blades Changing the oil Checking and adjustment of the throttle wire Replacement of the fuel filter TROUBLE SHOOTING SCHEDULE Problem Procedure Winter storage STORAGE Service TECHNICAL DATA EU declaration of conformity