18 – English
50 100
MAINTENANCE
25
!WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
•The engine is switched off.
•The ignition key is removed.
•The ignition cable is removed from the plug.
•The parking brake is applied.
•The cutting unit is disengaged.
Maintenance schedule
The following is a list of the maintenance which should be conducted on the machine. For the items which
are not described in these instructions go to an authorised service workshop.
Check the engine’s oil level 20 ●
Check the engine’s cooling air inlet 20 ●
Check the fuel pump’s air filter 20 ●
Check the steering wires 21 ●
Check the battery 22 ●
Check the safety system 22 ●
Check screws and nuts – ❍
Check for fuel and oil leakage – ❍
Clean the air filter’s pre-filter (foam plastic) 2) 23 ●
Check the cutting unit 25 ●
Check the tyre pressures (60 kPa) 32 ●
Change the engine oil 1) 34 ●
Check the V-belts – ❍
Check the hydrostat’s cooling fins – ❍
Check the transmission’s oil level 22 ●
Adjust the brakes 21 ●
Lubricate joints and shafts 3) 32 ●
Check and adjust the throttle wire 35 ●
Clean the engine’s and hydrostat’s cooling flanges 2,4) –❍
Replace the air filter’s pre-filter and paper filter 2) 23 ●
Replace the fuel filter 35 ●
Replace the plug – ❍
1) First change after 5 hours. 2) During dusty conditions cleaning and replacement should be more frequent. 3) For daily use of the
machine lubrication should be conducted twice a week. 4) Conducted by authorised service workshop.
Daily
mainte-
nance
before start
●= Described in these instructions.
❍= Not described in these instructions.
Maintenance Page
Maintenance interval
in hours