Driving
Before starting
•Read the safety instructions and information concerning the placement of controls and functions before starting.
•Perform daily maintenance before starting as set out in the Maintenance schedule.
IMPORTANT INFORMATION
The air intake grille in the engine cover behind the driver’s seat must not be blocked by, for example, clothing, leaves, grass or dirt. Impaired cooling of the engine.
Risk of major engine damage.
Start the engine
1Make sure that the clutch control is depressed. Rider 175 AWD has one control for the front axle and one control for the rear axle.
2Lift up the cutting unit by pulling the lever backwards to locked position (transport position) and apply the parking brake.
Rider 175 AWD The engine can not be started if the parking brake is not pressed down.
Starting a cold engine
3Move the throttle to position 3 (choke position). In this position the engine is fed with a richer mixture, which means the engine is easier to start.
Starting a warm engine
Move the throttle in between positions 1 and 2.
4 Turn the ignition key to the start position.
5When the engine starts release the ignition key immediately back to neutral position.
IMPORTANT INFORMATION
Do not run the starter for more than about 5 seconds at a time. If the engine does not start, wait about 15 seconds before trying again.
6Push the throttle control to full throttle position. Let the engine run at moderate speed or half throttle for
7 Set the required engine speed with the throttle control.
WARNING! Never run the engine indoors, in
!enclosed or poorly ventilated areas. The exhaust fumes contain toxic carbon monoxide.
English – 15