START AND STOP
Control before starting
•Inspect the working area. Remove objects that can be thrown.
• Check the blades. Never use blades that are dull, cracked or damaged.
•Check that the hedge trimmer is in full
working order. Check that all nuts and bolts are tightened correctly.
•Make sure the gearbox is lubricated correctly. See the section ”Lubricating the blades”.
•Ensure the blades always stop when the engine is idling.
•Only use the machine for what it is intended for.
•Ensure that the handle and safety functions are in order. Never use a machine that lacks a part or has been modified outside of the specifications.
Start and stop
Start
!WARNING!
The gearbox and clutch drum must be fitted before the machine is started, otherwise the clutch can become loose and cause personal injury.
Always move the hedge trimmer about 3 metres from the filling position before starting. Place the machine on a flat surface. Bear in mind that the blades start to move when the engine is started. Make sure the blades cannot come into contact with any object. Make sure that no unau- thorised persons are in the working area, otherwise there is a risk of serious personal injury.
Cold engine
IGNITION:
Set the stop switch to the start position.
CHOKE: |
|
Set the choke control in the |
|
choke position (A). |
|
The choke position is also |
|
the automatic start throttle | A |
position. |
|
AIR PURGE:
Press the air purge dia- phragm repeatedly until fuel begins to fill the diaphragm. The diaphragm need not be completely filled.
Warm engine
IGNITION:
Set the stop switch to the start position.
CHOKE:
Set the choke control in the choke position and then back again to its original position (B)
In this way only the start throttle is applied with no choke.
AIR PURGE:
Press the air purge dia- phragm repeatedly until fuel begins to fill the diaphragm. The diaphragm need not be completely filled.
Press the machine body against the ground using your left hand (NOTE! Do not use your foot). Grip the starter handle with your right hand and slowly pull the starter cord out until you feel some resistance, (the starter hooks grip) now quickly and powerfully pull the cord. Immediately press the choke control in when the engine fires and repeat until the engine starts. When the engine starts, quickly apply full throttle and the start throttle will automatically disengage.
NOTE! Do not pull the starter cord out completely and do not release the starter cord from the fully extended position. This can damage the hedge trimmer.
Stop
The engine is stopped by switching the ignition off using the stop switch.
B
English – 13
