Husqvarna 225L/LD, 232L Assembling the spray guard and, trimmer head Superauto, cutting equipment

ASSEMBLY

Assembling the spray guard and	Assembling other guards and
trimmer head Superauto II	cutting equipment

• Fit the guard (A) intended
	for use with the trimmer
	head. Secure using the 4
	bolts (L) and the support
	plate (M) as set out in the
	diagram.		K
•	Fit the drive disc (B) on the		J
	output axle.
			I
•	Turn the blade axle until
	one of the holes in the
	drive disc aligns with the		K
	hole in the gear housing.
•	Insert the locking pin (C)
	in the hole so that the axle	G
	is locked.	F	B
		I
			C
• The trimmer head must be		M
	split to be fitted (see the	L
	diagram). Proceed as
	follows:
•	Insert your finger into the
	centre hole of the cover (I)		A
	at the same time as you
	hold the cover with your
	other fingers. Press the two
	catches (J) that extend from
	the cut-out on the bottom
	section (K) using the
	thumb and index finger of
	your other hand. Press
	apart the trimmer head
	using the fingers on the
	cover.

•Place the cover (I) and the support flange (F) on the output axle.

•Fit the nut (G). The tightening torque of the nut is 35-50 Nm (3,5-5 kpm). Use the socket spanner in the tool kit.

Hold the handle of the

spanner as close to the trimmer guard as possible. The nut is tightened when the spanner is turned against the direction of rotation (left-hand thread).

•Fit the trimmer head‘s bottom section (K) on the cover (I) by pressing the two sections together with the cut-outs on the bottom section aligned with the catches on the cover.

•To dismantle follow the instructions in the reverse order.

•Fit the guard (A) intended for use with the trimmer head. Secure using four bolts

(L)and the support plate

(M)as shown in the diagram.

•Fit the disc drive (B) on the output axle.

•Turn the blade axle until one of the disc drive’s holes aligns with the corresponding hole in the gear housing.

•Insert the locking pin

(C)into the hole to lock the axle.

•Screw on the trimmer head (H) in the direction of rotation.

•Dismantling takes place in the reverse order.

A	L	B
		C
M
	H

English – 13