| START AND STOP | |
Control before starting | Cold engine | |
For reasons of safety follow | IGNITION: | |
Set the stop switch to the | ||
these recommendations! | start position. | |
• Check that the support | CHOKE: | |
Set the choke control in the | ||
flange is not cracked due | choke position. | |
to fatigue or due to being |
| |
tightened too much. | Warm engine | |
Discard the support | Use the same starting | |
flange if it is cracked. | procedure as for the cold | |
• Ensure the locking nut | engine, but do not set the | |
choke control in the choke | ||
has not lost its captive | position. The start throttle | |
force. The nut lock | position is obtained by | |
should have a locking | setting the choke control in | |
force of at least 1.5 Nm. | the choke position and then | |
The tightening torque of | returning it to its original | |
the locking nut should be | position. | |
| ||
• Check that the guard is | Stop | |
not damaged or cracked. | The engine is stopped by | |
Replace the guard if it is | switching off the ignition. | |
exposed to impact or is |
| |
cracked. |
| |
• Check that the trimmer |
| |
head and spray guard are |
| |
not damaged or cracked. |
| |
Replace the trimmer head |
| |
or spray guard if they are |
| |
exposed to impact or are | WARNING! | |
cracked. | ||
When the engine is started with the choke | ||
| ||
• Never use the machine | ! in the choke or start position the cutting | |
without a guard or spray | equipment starts to rotate immediately. | |
guard nor with a defective |
| |
guard. |
|
|
| Start | |
|
| Press the machine body | |
|
| against the ground using | |
|
| your left hand (NOTE! Not | |
|
| your foot). Grip the starter | |
|
| handle, slowly pull out the | |
|
| cord with your right hand | |
|
| until you feel some resistance | |
Start and stop | (the starter pawls grip), now | ||
quickly and powerfully pull | |||
|
| the cord. | |
! | WARNING! | Reset the choke control as | |
soon as the engine fires and | |||
The complete clutch cover with shaft | repeat until the engine starts. | ||
must be fitted before the machine is | When the engine starts | ||
started, otherwise the clutch can become | |||
| quickly apply full throttle | ||
| loose and cause personal injury. | ||
| and the start throttle will | ||
| Always move the machine from the filling | ||
| automatically disengage. | ||
| area before starting. Place the machine on | ||
| NOTE! Do not pull the | ||
| a flat surface. Ensure the cutting | ||
| equipment cannot come into contact with | starter cord out completely | |
| any object. Make sure no unauthorised | and do not release the starter | |
| persons are in the working area, | cord from the fully extended | |
| otherwise there is a risk of serious | position. This can damage | |
| personal injury. The safety distance is 15 | the machine. | |
| metres. | ||
|
| ||
|
| English – 15 | |
