ASSEMBLY
Assembling and dismantling the two-part shaft (225RD/ 232RD)
Assembling:
• Make sure the handle is loose.
• Guide the
• Tighten the handle.
Dismantling
• Undo the handle (at least three turns).
•Press the handle towards the coupling.
• Carefully twist the lower section out of the lock.
•Hold both parts of the shaft and pull out the lower section from the coupling.
20 – English
Adjusting the harness and clearing saw
!WARNING!
When working with the clearing saw it should always be hooked in the harness. If this is not done, you cannot control the clearing saw safely and this can result in injury to yourself or someone else. Never use a harness with a defective quick release catch.
Quick release
On the front is an easily accessible, quick release catch. This is activated by pulling the outer part of the chest plate straight out. Use this if the engine should catch fire or in any other emergency situation when you quickly need to take off the harness and machine.
Even load on the shoulders
A
Correct height
1) Forestry clearing Adjust the carrier strap so that the suspension hook comes approximately 10 cm under the hip. The blade should be angled forward a little.
2)Grass clearing
The suspension hook should hang approximately 20 cm under the hip so that the blade is parallel to the ground.
Correct balance 1)Forestry clearing
Move the suspension eye forwards or backwards. If the blade is balanced a 10- 20 cm above the ground it is easier to avoid stones.
2)Grass and brush cutting. Let the blade balance at a comfortable clearing height, i.e. close to the ground.
