START AND STOP

!WARNING!

Starting with the start throttle function connected can give an uncontrolled activation of the cutting equipment.

Start

Press the machine body to the ground with the left hand. (NOTE: Not with the foot!) Grip the start handle, pull the start line slowly out with the right hand until a resistance is felt (the start hooks engage) and then make a quick and strong pull. Open the choke

control immediately when the engine ignites and make repeated attempts to start until the engine starts. When the engine starts, give full throttle and the start throttle will automatically disconnect.

NOTE!

Do not pull the starter cord out completely and do not release the start handle from the fully drawn position. This can cause damage to the engine.

NOTE!

An new machine which is started for the first time should be run for a maxi- mum of half a minute with repeated throttle starts, after which hydraulic oil must be replenished in the hydraulic oil tank until the level is correct. Repeat this procedure until the level in the hydraulic tank stabilises.

!WARNING!

The hydraulic oil can during and after use be very hot. Avoid contact with the skin.

Connection of the engine unit

Hang the engine unit on the harness.

Make sure the hydraulic hoses are on the right side of the harness (viewed from behind). Exhaust fumes will then be directed backwards, away from the

harness.

A

Fit the lock spring (A).

Fitting the harness

Put on the harness with engine unit.

Press together the hip belt’s snap lock.

Tension the hip belt so that it rests on the hips.

Tension both shoulder belts so that the harness presses to the back.

Removing the harness

Switch off the engine.

Release the hip belt’s snap lock.

Pull one arm out of the shoulder belt and lower the harness and engine unit to the ground with the other hand.

Quick release in case of hazard

Pull out the red strap.

The hip belt and one shoulder belt will be automatically released at the same time and the harness and engine unit will slide to the ground.

English – 19

Page 19
Image 19
Husqvarna 250PS manual Start and Stop, Connection of the engine unit, Fitting the harness, Removing the harness