ENGLISH
MOUNTING GUIDE BAR AND ADJUSTING CHAIN
CAUTION!
Always disconnect power before performing cleaning or maintenance work.
CAUTION!
A loose chain can jump out of its groove during operation and cause serious or even fatal injury.
6. Replace the chain drive cover and screw the mounting nut hand tight.
1. Pull kickback guard back against the front handle to ensure that the chain brake is not applied.
2.Screw out the guide bar nut and remove the chain drive cover.
2
3.Fit the chain around guide bar nose with the top cutters facing forwards.
4.Holding the chain over the guide bar nose, position the back end of the guide bar against the drive sprocket at a 45° angle to the power head. Pass the free end of the chain around the drive sprocket, swing the guide bar into place over the mounting bolt and against the power head, and guide the chain into the guide bar groove.
5. Seat the guide bar tensioner pin in its hole in the guide bar.
7. Tension the chain by screwing the tensioning screw clockwise using the screwdriver tip on the combination tool.
8.Tighten chain firmly but not so hard that it does not turn easily by hand force. Push the button to release the chain brake. To avoid contact between your hands and the chain, use gloves to turn the chain.
8
9.Tighten the mounting nut with the combination tool while hold- ing the tip of the guide bar up.
The tension of a new chain must be checked frequently until it is broken in. Continue to check the tension at regular intervals to ensure good performance and a long service life.
•Wear causes a chain to become looser with use. Regular tensioning is important to compensate for this wear.
•Check the chain tension at least every time you refill the chain oil reservoir.
10
