Husqvarna 324RX-Series Grass clearing using a grass blade, Grass trimming with a trimmer head

SAFETY INSTRUCTIONS

Grass clearing using a grass blade

•Grass blades and grass cutters must not be used on woody stems.

•A grass blade is used for all types of tall or coarse grass.

•The grass is cut down with a sideways, swinging movement, where the movement from right-to-left is the clearing stroke and the movement from left-to-right is the return stroke. Let the left-hand side of the blade (between 8 and 12 o’clock) do the cutting.

•If the blade is angled to the left when clearing grass, the grass will collect in a line, which makes it easier to collect, e.g. by raking.

•Try to work rhythmically. Stand firmly with your feet apart. Move forward after the return stroke and stand firmly again.

•Let the support cup rest lightly against the ground. It is used to protect the blade from hitting the ground.

•Reduce the risk of material wrapping around the blade by following these instructions:

1 Always work at full throttle.

2 Avoid the previously cut material during the return stroke.

•Stop the engine, unclip the harness and place the machine on the ground before you start to collect the cut material.

WARNING! Neither the operator of the

!machine nor anyone else may attempt to remove the cut material while the engine is running or the blade is rotating, as this can result in serious injury.

Stop the engine and blade before you remove material that has wound around the blade shaft as otherwise there is a risk of injury. The bevel gear can get hot during use and may remain so for a while afterwards. You could get burnt if you touch it.

WARNING! Watch out for thrown objects.

!Always wear eye protection. Never lean over the cutting attachment guard. Stones, rubbish, etc. can be thrown up into the eyes causing blindness or serious injury.

Keep unauthorised persons at a distance. Children, animals, onlookers and helpers should be kept outside the safety zone of 15 m. Stop the machine immediately if anyone approaches. Never swing the machine around without first checking behind you to make sure no-one is within the safety zone.

Grass trimming with a trimmer head

Trimming

•Hold the trimmer head just above the ground at an angle. It is the end of the cord that does the work. Let the cord work at its own pace. Never press the cord into the area to be cut.

•The cord can easily remove grass and weeds up against walls, fences, trees and borders, however it can also damage sensitive bark on trees and bushes, and damage fence posts.

•Reduce the risk of damaging plants by shortening the cord to 10-12 cm and reducing the engine speed.

Clearing

•The clearing technique removes all unwanted vegetation. Keep the trimmer head just above the ground and tilt it. Let the end of the cord strike the ground around trees, posts, statues and the like. CAUTION! This technique increases the wear on the cord.

•The cord wears quicker and must be fed forward more often when working against stones, brick, concrete, metal fences, etc., than when coming into contact with trees and wooden fences.

•When trimming and clearing you should use less than full throttle so that the cord lasts longer and to reduce the wear on the trimmer head.

English – 13