ASSEMBLY
arrow in the diagram shows the area where you should operate the socket spanner when loosening or tightening the nut.
Fitting a trimmer guard and Superauto II 1" trimmer head
|
| K |
K | G |
|
F | B | |
| I | |
J | I | C |
|
| |
|
| A |
•Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard onto the fitting on the shaft and secure with the bolt (L).
•Fit the drive disc (B) on the output shaft.
•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
•To fit the trimmer head, first separate the two halves (see diagram). Proceed as follows:
-Insert a finger into the centre hole of the cover (I) while grasping the cover with your other fingers. Using the index finger and thumb of your other hand, release the two catches (J) that engage in the
•Place the cover (I) and the support flange (F) on the output shaft.
•Fit the nut (G). Tighten the nut to a torque of
•To tighten the nut, turn the spanner in the opposite direction to the direction of rotation (Caution!
•Fit the bottom half of the trimmer head (K) to the cover (I) by pressing them together, with the
•To dismantle, follow the instructions in the reverse order.
Fitting other guards and cutting attachments
•Fit the trimmer guard/combination guard (A) intended for use with the trimmer head/plastic blades. Hook the guard onto the fitting on the shaft and secure it with the bolt (L).
•Fit the drive disc (B) on the output shaft.
•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
•Screw on the trimmer head/plastic blades (H) in the opposite direction to the direction of rotation.
H
H
•To dismantle, follow the instructions in the reverse order.
18 – English
