Husqvarna 355FXT, 355FRM manual 355RX

ASSEMBLY

355RX

•Fit the holder (R) and bracket (J) with 2 bolts (H) on the gear housing.

•Then fasten the blade guard (A) with 4 bolts (L) in the holder (N).

H

J

K R

L

A

•Fit the drive disc (B) on the output shaft.

•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

•Insert the locking pin (C) in the hole to lock the shaft.

•Place the blade (D) and support flange (F) on the output shaft.

G

F

D

B

C

•Fit the nut (G). The nut must be tightened to a torque of 35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool kit. Hold the shaft of the spanner as close to the blade guard as possible. To tighten the nut, turn the spanner in the opposite direction to the direction of rotation (Caution! left-hand thread).

When loosening and tightening the saw blade nut, there is a risk of injury from the teeth of the saw blade.You should therefore always ensure that your hand is shielded by the blade guard when doing this. Always use a socket spanner with a shaft that is long enough to allow this. The

arrow in the diagram shows the area where you should operate the socket spanner when loosening or tightening the nut.

Fitting the shredder blade and the shredder blade guard (355FRM)

•Fit the holder (K) and bracket (J) with 4 bolts (H) on the gear housing.

H

J

K

•Then fasten the shredder blade guard (A) with 4 bolts in the holder as shown.

A

x 4

English – 17