Maintenance | Husqvarna 355RX, 355FXT, 355FRM guide

MAINTENANCE

particular attention that the opening on the air duct is positioned in the centre of the hole in the air ﬁlter holder.

IMPORTANT! If the temperature rises above -5°C or 0°C respectively the machine MUST be restored to its normal set-up. Otherwise there is a risk of overheating, which can cause severe engine damage.

IMPORTANT! Any maintenance other than that described in this manual must be carried out by your servicing dealer (retailer).

34 – English

Image 34

Husqvarna 355RX, 355FXT, 355FRM manual Maintenance

Contents

355FX 355FXT 355RX 355FRM KEY to Symbols Symbols Contents Introduction Dear Customer What is WHAT? What is what on the brush cutter? 355RX What is what on the brush cutter? 355FX, 355FXT What is what on the brush cutter? 355FRM General Safety Precautions Personal protective equipment Machine′s safety equipment Throttle lockout Vibration damping system Stop switchCutting attachment guard Quick release Mufﬂer Locking nut Cutting equipment Cutting equipmentLocking screw General rules Bent, twisted, cracked, broken or Sharpening grass cutters and grass bladesSharpening the saw blade To straighten a twisted blade so that it Trimmer head Transport position, handlebar AssemblyAssembling the handlebar and throttle Assembling the cutting equipment Fitting the blade guard and saw blade 355FX, 355FXT 355RX Fitting other guards and cutting attachments Adjusting the harness Adjusting the harness and brush cutterSafety release Triobalance harness Correct balance Grass clearing Fuel Handling Fuel safetyFuel Fuelling Mixing Starting and stopping Starting and StoppingCheck before starting Cold engine Stopping Warm engineStarting Heated handles General working instructions Basic safety rulesWorking Techniques ABC of clearing Working Techniques Forestry clearing using a saw blade Grass trimming with a trimmer head Grass clearing using a grass bladeBrush cutting with a saw blade Trimming Cutting Shredding dense vegetation with a shredder bladeSweeping Maintenance Carburettor Air ﬁlter MufﬂerCooling system Is damaged it should be replaced Drive shaft Bevel gearSpark plug Temperature -5C or colder Temperature 0C or colderWinter use Maintenance Maintenance schedule Maintenance Daily Weekly Monthly Technical Data Technical data Centre hole in blades/cutters, Ø 25,4 mm EC-declaration of conformity Applies to Europe only Trimmy SII Page Auto T45, T45x T55x Original instructions 1153302-26