Mufﬂer, Chain catcher | Husqvarna 1153177-95, 395XPG specs

MAINTENANCE

Chain catcher

Check that the chain catcher is not damaged and is ﬁrmly attached to the body of the chain saw.

Right hand guard

Check that the right hand guard is not damaged and that there are no visible defects, such as cracks.

Vibration damping system

Regularly check the vibration damping units for cracks or deformation.

Make sure the vibration damping units are securely attached to the engine unit and handle unit.

Stop switch

Start the engine and make sure the engine stops when you move the stop switch to the stop setting.

Mufﬂer

The mufﬂer is designed to reduce the noise level and to direct the exhaust gases away from the operator. The exhaust gases are hot and can contain sparks, which may cause ﬁre if directed against dry and combustible material.

Some mufﬂers are equipped with a special spark arrestor screen. If your machine has this type of mufﬂer, you should clean the screen at least once a week.This is best done with a wire brush. A blocked screen will cause the engine to overheat and may lead to serious damage.

Note! The screen must be replaced if it is damaged. If the screen is blocked the machine will overheat and this will cause damage to the cylinder and piston. Never use a machine with a mufﬂer that is in poor condition. Never use a mufﬂer if the spark arrestor screen is missing or defective.

English – 33

Image 33

Husqvarna 1153177-95, 395XPG manual Mufﬂer, Chain catcher

Contents

395XP 395XPG KEY to Symbols Symbols on the machineSymbols in the operator’s manual EPA Contents Dear customer Introduction What is what on the chain saw? What is WHAT? Before using a new chain saw General Safety Precautions Always use common sense Machine′s safety equipmentPersonal protective equipment Chain brake and front hand guard General Safety Precautions Throttle lockout Chain catcherRight hand guard Cutting equipment Stop switchVibration damping system Mufﬂer Cutting equipment designed to reduce kickback BarChain General information on sharpening cutting teeth Sharpening your chain and adjusting depth gauge setting Adjustment of depth gauge setting Increased if the depth gauge setting isTensioning the chain Too large Filling with chain oil Lubricating cutting equipmentChecking chain lubrication Chain drive sprocket Checking wear on cutting equipment Needle bearing lubrication Assembly Fitting the bar and chainWorking with the chain Fuel Fuel Handling Fueling Fuel safetyTransport and storage Long-term storage Starting and stopping Starting and StoppingCold engine Warm engine Stopping Working Techniques Basic safety rulesBefore use General working instructions General rules Terms Basic cutting technique Limbing Safe distance Tree felling techniqueFelling direction Clearing the trunk and preparing your retreat Felling cut Directional cuts How to avoid kickback What is kickback?Freeing a tree that has fallen badly Cutting the trunk into logs Carburetor adjustment Maintenance Correctly adjusted carburetor Fine adjustment of the idling speed THigh speed jet H Checking brake band wear Immediately Checking the inertia brake release Mufﬂer Changing a broken or worn starter cord StarterTensioning the recoil spring Changing a broken recoil spring Spark plug Air ﬁlterLubricating the bar tip sprocket Fitting the starter Air Injection centrifugal cleaning Adjustment of the oil pumpWhen making adjustments Needle bearing lubrication Heated handles Winter use Daily maintenance Weekly maintenance Monthly maintenance Maintenance schedule Technical data Technical Data 050/1,3 mm Saw chain ﬁling and ﬁle gauges058/1,5 mm 063/1,6 mm Your Warranty Rights and Obligations Federal Emission Control Warranty Statement Emission Controlwarranty Parts List Safety precautions for chain saw users American Standard Safety PrecautionsKickback safety precautions Other safety precautions Original instructions 1153177-95