Husqvarna 36, 41 manuel dutilisation Chainmaintenance, 1111, ’Jl

Chainmaintenance

	Sharpening
	Never cut with a dull saw chain. A chain which does not cut
	unless you press it hard against the wood is damaged, dull or
	incorrectly filed. In order to file the chain correctly you need:
	round file (A), file gauge (B), flat file (C) and a depth gauge tool
	(D). By using the correct file size (see the table) and an file gauge
	with a marked filing angle, it is easier to receive a good result.
	NOTE! Check that the drive link does no?have a too large play in
	the bar groove. This can give an incorrect filing result. Always file
	from the inside of the teeth and out. Then turn the saw and file on
	the other side. In order to receive a straight cut in the wood, all
	the teeth should be filed to the same length. If the chain is filed
	regularly, only a few strokes are needed on every saw tooth. For
	the best performance, every chain type has different cutting
—	angles, file sizes and filing depth (see the table).
	1

~WARNING! If a too small filing size is used or the file is kept too deep in the cutting tooth, the chain will be dangerously

	aaoressive. This means that kick-back can occur.
I	. .

1111

1’	min 4 mm
*	,,,,,,,,.,.,,,
.	‘ ,
	...., ,

Depth gauge

In order to receive the best performance and life time of the chain, always keep the prescribed depth gauge setting.

~WARNING ! A too big depth gauge makes the chain dangerously aggressive. This means that kickback can occur.

B00

0,65 mm ~

			—, -			C!2h~		.......,,)..
			l-l					f-J’Jl
						+
								#
						o ~o		00
							e“’””
						“’1””~		●
					@	00		$’,.,
+30	.325		0.05011.3	311614,8		85°	10°	.025/0,65	Xiiii&d
						A	d d
	inch	I	inch/mm	inch/mm		o	c’	inchlmm
14Sl_&G .325		1		I	14,5	60°	o“	.025/0,65
			0.058/1,5
r130	.325		0.050/1;3	3/16/4,8		85°	10°	.02510,65	1614118618146172	13
91SG	3/8		0.050/1,3	5J32J4,5		85°	o“	.025/0,65	1413515216t39156