Startand stop

Start and stop

~WARNING!

Neverstartthe sawenginewithoutthe bar,chainandclutch cover(chainbrake)assembled- or elsetheclutchcancomeloose andcausepersonalinjuries.

Alwaysmovethe sawawayfromthefuelingareabefore starting.

Placethe sawon cleargroundandmakesure that the chain is not contacting anything. Also, make sure that you have a secure footing.

Keep people and animals well away from the working area.

I

Start

Grio the front handle with vour left hand and hold the saw down CAUTION!by putting your right foot ii the rear handle.

Pull the starter handle with your right hand and pull out the starter cord slowly until the starter pawls engage. Then pull sharply. Push in the choke control immediately when the engine ignites and make repeated starting attemps.

When the engine starts, rapidly give full throttle. Then the throttle latch will disengage.

Do not release the starter handle from fully pulled out position as this can cause damage on the saw.

&

3

l/{

/g. —-

‘u

 

,j

-—

—.

 

 

!’,

~

 

 

r=———

, \

——

 

 

i.—

—,

\.\

\“/)/

Cold engine

CHAIN BRAKE: Disengagethe chain brake by pulling the hand

IGNITION:

guard towards he front handle.

Move the ignition switch to the left.

CHOKE:

Pull out the choke control

I FAST IDLE:

Combined choke/fast idle is received when the

I

choke is moved to choke position.

 

Iqs+armengine

Use the sam~ procedure as for starting cold engine but without

choke. Fast idle is recived by pulling out the choke fully first, and \s\ pressing it back again.

stop

The engine is stopped by switching off the ignition. (Move the ignition switch to the right.)

8

Page 8
Image 8
Husqvarna 41, 36 manuel dutilisation Startand stop