ASSEMBLY
Fitting the loop handle
•Position the handle on the shaft. Note that the handle must be mounted below the arrow on the shaft.
•Slide the spacer into the slot in the loop handle. Fit the nut and screw. Tighten.
Assembling the cutting equipment
WARNING! Never use a cutting
! attachment without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.
Fitting the trimmer guard and trimmer head
•Fit the correct trimmer guard (A) for use with the trimmer head.
A
•Tighten the two screws.
•Fit the drive disc (B) on the output shaft.
•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
•Screw on the trimmer head (D) in the opposite direction to the direction of rotation.
10 – English
