Lubricating the bar tip sprocket | Husqvarna 436 LI, 536 LIXP

MAINTENANCE

Power trigger lockout

•Make sure that the power trigger is locked at the idle setting when the power trigger lockout is released.

•Press the power trigger lockout and make sure it returns to its original position when released.

•Check that the power trigger and power trigger lockout move freely and that the return springs work properly.

•Activate the chain saw and apply full power. Release the power trigger and check that the saw chain stops and remains stationary.

Chain catcher

Li-ion

•Check that the chain catcher is not damaged and is ﬁrmly attached to the body of the chain saw.

Keypad

•Activate the chain saw (green LED on) and make sure the chain saw deactivates when the start/stop button is pressed (green LED off).

Lubricating the bar tip sprocket

Li-ion

•Lubricate the bar tip sprocket each time you reﬁll with saw chain oil. Use the special grease gun and a good quality bearing grease.

Battery connectors

Clean the battery and the machines battery compartment with a soft brush after use. Make sure all cooling slots and battery connectors are cleaned.

36 – English

Image 36

Husqvarna 436 LI, 536 LIXP manual Lubricating the bar tip sprocket, Battery connectors, Power trigger lockout

Contents

436 Li, 536 LiXP KEY to Symbols Symbols on the machineSymbols on the battery and/or on the battery charger Symbols in the operator’s manual Contents Introduction Dear Customer What is WHAT? What is what on the chain saw? General Safety Precautions General power tool safety warnings Battery tool use and care ServiceChain saw safety warnings Causes and operator prevention of kickback Before using a new chain saw Always use common sense Personal protective equipment Machine′s safety equipment Automatic switch off functionalityKeypad Chain brake and front hand guard General Safety Precautions Battery and battery charger Battery charger safety Cutting equipmentGeneral rules Cutting equipment designed to reduce kickback Sharpening your chain and adjusting depth gauge setting General information on sharpening cutting teeth General advice on adjusting depth gauge setting Adjustment of depth gauge settingTensioning the chain Too large LiXP 436 LiLubricating cutting equipment Filling with chain oil Checking chain lubricationChain drive sprocket Checking wear on cutting equipment Assembly Fitting the bar and chainWorking with the chain Fitting a spike bumper Battery Handling BatteryBattery charger Disposal of the battery, battery charger and machine Transport and storageLED display Charging status Starting and Stopping Starting and stoppingStarting Starting Stopping Basic safety rules Working TechniquesBefore use SavE General rules Basic cutting technique Not safely controlled with one handHandles with both hands General Tree felling technique Log is supported at both ends. There is a high riskSafe distance Felling direction Clearing the trunk and preparing your retreat Felling Training we advise you not to fell treesYour saw Directional cuts Freeing a tree that has fallen badly Freeing a trapped tree How to avoid kickback What is kickback? Cutting the trunk into logs Maintenance GeneralChecking the front hand guard Checking the inertia brake release Battery connectors Power trigger lockoutLubricating the bar tip sprocket Cooling system Maintenance schedule Daily maintenance Weekly maintenance Monthly maintenance Troubleshooting schedule BatteryBattery charger Keypad Possible faults Possible action Technical Data Technical data Guide bar and saw chain combinations Saw chain ﬁling and ﬁle gauges EC-declaration of conformityApplies to Europe only Page Page 1154476-26