MAINTENANCE
Cleaning
Switch off your lawnmower, wait until the blade has stopped rotating and disconnect from the mains electricity supply,
It is very important that you keep your lawnmower clean! Grass clippings left in any of the air intakes or under the deck could become a potential fire hazard.
1.Remove grass from under the deck with a brush (N1 and N2).
Cutting System (P)
Always handle the blade with care - sharp edges could cause injury.
USE GLOVES
Renew your metal blade after 50 hours mowing or 2 years whichever is the sooner - regardless of condition.
If the blade is cracked or damaged replace it with a new one.
Removing the Blade and Fan
1. Turn your lawnmower on its' side. To |
remove the blade bolt, hold the fan |
N1 |
N2 |
firmly and with the spanner provided |
loosen the blade bolt by turning it anti- |
clockwise. |
2. Remove the blade bolt, blade, fan and |
fan insert. Inspect for damage and |
clean as necessary.
Fitting the Blade and Fan
1. Ensure drive hub is securely in position. |
Place fan on drive hub . |
2.Using a soft brush - remove grass clippings from the deck (N3), cutting height adjustment area, grassbox and ejection chute (N4).
2. Locate blade spacer onto fan ensuring |
that the slots on the blade spacer |
engage with the ribs on the fan.
•The curved washer should only be fitted one way.
N3 |
N4 |
3.Fit the curved washer over the blade bolt ensuring the outer curved side fits against the bolt head
4.Place the blade bolt through the centre hole in the blade ensuring that the blade is the correct way up - i.e. with the Husqvarna part number on the bolt head side.
5.Engage the P
3.Wipe over the surface of your lawnmower with a dry cloth.
IMPORTANT
Never use water for cleaning your lawnmower. Do not clean with chemical, including petrol, or solvents - some can destroy critical plastic parts.
English - 7
blade bolt through the centre hole of the blade spacer and tighten clockwise by hand
6. Hold the fan firmly and tighten the blade bolt with the spanner provided.
