Husqvarna 45-0352 Attach Bag Bottom, Attach Bag Sides, Assemble Support Rods, Snap, Clevis Pin N

STEP 17 - ATTACH BAG BOTTOM

7.Assemble the bag retainer and the bag frame strap to the front edge of the bag bottom. Place the bag retainer on top and the bag frame strap underneath the bag bottom. Fasten together using six #10 x 5/8" screws and #10-32 nylock nuts. See fi gure 17.

FRONT EDGE OF BAG BOTTOM

STEP 18 - ATTACH BAG SIDES

9.Fold the bag fl aps around the lower hopper tubes and attach to the bag bottom using the snaps. See fi gure 19.

FRAME STRAP	SNAP	FLAP
#10-32 x 5/8" SCREW
BAG RETAINER

#10-32

NYLOCK NUT

FIGURE 17

FIGURE 19

8.Assemble the bag frame strap to the holes in the lower hopper tubes using two 1/4" x 1-1/8" clevis pins and small hair cotter pins. See fi gure 18.

BAG FRAME STRAP

SMALL HAIR

COTTER PIN

CLEVIS PIN (N)

STEP 19 - ASSEMBLE SUPPORT RODS

IMPORTANT: Do not over bend the support rods during the following step.Over bending will decrease the supporting tension of the rods.

10.Assemble the two hopper support rods as shown in fi gure 20. Place the ends of the rods into the holes in the upper and lower hopper tubes, fl exing the rod just enough to fi t into the holes in the tubes.

SUPPORT

RODS

FIGURE 18

FIGURE 20

8