Toshiba B-SA4T installation manual 3ADJUST SET Feed ADJ

INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT

EO15-33001A

(Revision Date: Jan. 19, 2006)

2. Strip Module

9.Turn off the printer, and then back to on. Send an issue command to the printer for strip issue.

10.If necessary, fine adjust the print start position and strip position in the system mode.

NOTES:

1.It is recommended that the print start position and strip position are adjusted on the actual print condition.

2.When short-pitch labels are used, the print start position may misalign on the first few labels. In that case, feed the labels between the media sensor and the strip shaft, and discard them.

Label Media Sensor

Strip Shaft

Discard labels between the media sensor and the strip shaft.

11.Repeat Steps 9 and 10 for position fine adjustment.

12.After the print position and strip position are properly adjusted, access “<2>PARAMETER SET” menu in the system mode again.

(Continued.)
Turn the power OFF.
Turn the power ON.
Issue labels.
Print position		Good
Adjustment
is required.
Power OFF
Power ON
	FEED	RESTART
<1>DIAG.
V1.1
Print position fine adjustment
<3>ADJUST SET
FEED ADJ.	+0.0mm
Strip position fine adjustment
<3>ADJUST SET
CUT ADJ.	+0.0mm
Turn the power OFF.
Turn the power ON.
	FEED	RESTART
<1>DIAG.
V1.1

FEED

<2>PARAMETER SET

Continued.

2- 6