Toshiba B-SA4T installation manual When Short-Pitch RFID Tags 20mm are used

INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT

EO15-33001A

(Revision Date: Feb. 25, 2008)

8. RFID Module: B-SA704-RFID-U2-EU-R

15. Re-place the Media Sensor Block.

Media Sensor Block

16.Connect the Antenna Cable to the Antenna Ass’y until it clicks, and fasten the Antenna Cable with the Cable Clamp, as shown below.

Antenna Cable Antenna Ass’y

Cable Clamp

17.Reattach the Side Panel to the printer with reference to Step 2.

18.Close the Front Cover and the Top Cover. Now, an installation of the RFID Module has been finished. In the case short-pitch RFID tags (20mm) are used, refer to Section 4 to attach the Shield Sheet and Section 5 to configure the RFID module settings.

When short-pitch tags are not used, refer to Section 5 to configure the RFID module settings.

•When Short-Pitch RFID Tags (20mm) are used:

When short-pitch tags (20 mm) are used, the supplied Shield Sheet needs to be attached for proper read/write operation.

Follow the procedure below to attach the Shield Sheet to the Media Guide Bock.

1.Before attaching the Shield Sheet, move the Media Sensor to the right-most position. Failure to do this disables a media sensor position adjustment.

Media

Sensor

8- 9