Toshiba B-SA4T installation manual Close the Strip Unit, System Mode Manual

INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT

EO15-33001A

2. Strip Module

5.Secure the Strip Unit to the printer with the two screws. Make sure that the Feed Roller Gear rotates smoothly.

Strip Unit

Feed Roller Gear SMW-3x6 Screw

6. Close the Strip Unit.

Strip Unit

7.Connect the Strip Harness to the connector at the front of the printer. At this time, carefully avoid contact of the strip harness with the gears.

Gear

Strip Harness

8.Close the Strip Module Cover.

Perform an operation check for a proper strip issue.

• Media loading procedure-------------	Owner’s Manual, Section 2.3
• Operation check------------------------	Owner’s Manual, Section 2.9
• System mode setting------------------	System Mode Manual
• Cleaning ---------------------------------	Owner’s Manual, Section 4.1.4
	2- 3

Connector

Strip Harness