Toshiba B-SA4T installation manual Attaching the Cutter, How to use the Guide Roller

SMW-3x6 Screw

INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT

EO15-33001A

(Revision Date: Jan. 19, 2006)

2. Strip Module

•Attaching the Cutter

The enclosed cutter is used to tear off the batch-issued labels. Attach the cutter with the two SMW-3x6 screws as shown in the picture below. Insert the leading edge of the labels into the opening under the cutter.

Opening

Strip Unit Cutter Edge

NOTE: Depending on the backing paper types, tearing off the backing paper against the slot of the strip module cover may cause it to wind onto the inner rollers. It is advisable to tear off or cut the backing paper outside the strip module cover.

Slot

•How to use the Guide Roller

When issuing the label with the length of 50 mm or more, fit the guide roller to the center of the strip module cover to prevent the stripped label from sticking to the cover.

Opening

Guide Roller

Strip Module Cover

NOTE: Regarding the system mode setting for use of PET paper, refer to Section 2.1.

2- 11