INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
2. Strip Module
2.Open the Front Cover wider. Remove the Front Cover by lifting it to disengage the hinge pins from the hinge. The Front Cover cannot be removed unless it is opened at an angle of over 100 degrees as the stoppers of the hinge prevent disengagement.
100°
Front Cover
HingeScrew
3. Mount the Strip Module Cover by inserting the hinge pins into the hinges.
Hinge
Strip Module Cover
4. Fit the Shaft Holders of the Backing Paper Feed Roller into the cuts of the printer.
Shaft Holder
Cut
Cut
Strip Unit
Backing Paper Feed Roller
2- 2
