10
Install the bagger mount tube to the rear guard 1.
with 5/16-18x3¼boltsandangenutsfromkit.
NOTE: Depending on model, rear guard hole may
need to be drilled out to 5/16"ifkithardwareistoo
large.
Installkitsupportstrapsontheoutsideofthe2.
mount tube as shown in the illustration. Using a
5/16-18 x 1¼ bolt, attach the front side of the strap
tothefendersupport.Donotaddangenutatthis
time. Place the reinforcement plate to the outside
of the fender support. Secure with additional 1¼
boltandfastenbothboltswithangenuts.Repeat
steps on opposite side.
NOTE:Thefrontsideofthekitsupportstraps
should be on the inside of the mower frame.
Tighten all hardware. 3.
ASSEMBLY
7INSTALLING BAGGER MOUNT
Reinforcement Plate
Mount Tube
Support Strap
Drill rear
guard hole to
5/16" if needed
Rear Guard
5INSTALLING BELT COVERS
1. Placethedeckbeltshieldonthedeckoverthe
drive pulley and secure with hardware removed
from steel belt shield.
2. Place retainer on the outer pulley cover.
3. Align the tab end of the belt cover into the slot on
thedeckbeltshield���andtheotherendovertheend
of the outer pulley cover.
4. Securewithknob.
Retainer
Knob
Outer Pulley Cover
DeckBeltShield
Belt Cover Tab
Middle Chute Latch
6INSTALLING MIDDLE CHUTE
1. Place middle chute over the top end of the blower
assembly.
2. Latch middle chute to blower assembly.
Middle Chute
Blower Assembly