ASSEMBLY
1DECK ADJUSTMENT
1.Locate the rear adjustment nut on the discharge side of the deck. To assure the right tighteness, mark the front side of the nut.
2.Using the mark as a guide, turn the nut clockwise five turns with a ¾" wrench.
2BAGGER SUPPORT ASSEMBLY
1. Slide the flanges of the support assembly in the slots in the drawbar. 
Support
Assembly
2.Pivot the assembly backwards to insert the bottom pin into the drawbar. Secure the bottom pin with a hairpin.
3MOUNTING BLOWER ASSEMBLY
1.Remove the discharge chute from the deck.
2.Lower deck to the lowest cutting position.
3.Remove the right hand (discharge side) belt cover from the deck.
4.Position blower over the discharge tabs on the deck and set blower onto the deck.
5.Be sure the blower is sitting flush against the outside of the deck.
Rear Mount Bracket
Contact Area
6.Install the front mount bracket to the deck with the pin and hairpin cotter supplied with the kit.
Hairpin Cotter 
| Pin | |
Outer Pulley | ||
Cover | ||
|
Hairpin
7
