Husqvarna 115 247227 R1, 966 445001 manual Assembly, 1BAGGER MOUNT - 2009 Models

ASSEMBLY

1BAGGER MOUNT - 2009 Models

1.Install the bagger mount tube to the rear guard with 5/16-18 x 3¼ bolts and flange nuts from kit. NOTE: Depending on model, rear guard hole may need to be drilled out to 5/16" if kit hardware is too large.

2.Install kit support straps on the outside of the mount tube as shown in the illustration. Using a 5/16-18 x 1¼ bolt, attach the front side of the strap to the fender support. Do not add flange nut at this time. Place the reinforcement plate to the outside of the fender support. Secure with additional 1¼ bolt and fasten both bolts with flange nuts. Repeat steps on opposite side.

NOTE: The front side of the kit support straps should be on the inside of the mower frame.

3.Tighten all hardware.

Drill rear guard hole
to 5/16" if needed	Support Strap

8063-044

BAGGER SUPPORT -2008 and Prior Models

Remove rear engine guard (if installed) by removing the six bolts that attach the guard to the frame.

1. Place hitch on the rear of the mower.

Engine	Engine
Guard	Guard
Bolts	Bolts
Rear Engine
Guard

8063-045

3.Install two of the previously removed bolts through rear of the hitch weldment.

4.Secure the sides of the hitch to the frame with 5/16-18 x ¾ bolts and washers from the new hardware, (two per each side).

Mount Tube	Reinforcement
	Plate

8063-046

Previously Hitch

Removed

Hardware

9