ASSEMBLY
2INSTALLING CHUTE SUPPORT
1.Position upper chute support against bagger inlet, flush at outer edges. See Illustration.
2.Using support as a template, drill two 3/8 holes into bagger hood.
Upper Chute Support
Bagger Inlet
3.Secure upper chute support to hood with hex bolts, washers and nyloc nuts.
Flex Trim
3CONTAINER MOUNTING
Remove plastic end caps from the center two bag support arms. Fully insert spacer plugs into the ends of the support tubes. It may be necessary to tap the spacers into place with a hammer or mallet. Replace the plastic end cap back over the spacer. The additional extension will hold the hood more securely when latched.
Insert spacers and
replace caps
Remove center
end caps
4MOUNTING COVER ASSEMBLY
NOTE: Assistance from another person may ease mounting the cover assembly to mower.
1.Lift and rotate cover to align the cover brackets with support assembly tubes.
2.Slide the cover down over the support tubes until secure.
10
