Husqvarna 967277601 Battery, Always wear eye protection when around batteries, Replacing battery

MAINTENANCE

Battery

Your mower is equipped with a maintenance free battery and does not need servicing. However, periodic charging of the battery with an automotive type battery charger will extend its life.

•Keep battery and terminals clean.

•Keep battery bolts tight.

•See chart for charging times.

CAUTION!

Always wear eye protection when around batteries.

Cleaning battery and terminals

Corrosion and dirt on the battery and terminals can cause the battery to lose power.

1.Open the terminal access doors.

2.Disconnect BLACK battery cable first, then the RED battery cable and remove the battery from the machine.

3.Rinse the battery with plain water and dry.

4.Clean terminals and battery cable ends with wire brush until shiny.

5.Coat terminals with grease or petroleum jelly.

6.Reinstall battery.

Replacing battery

1.Lift seat and rotate forward.

2.Using two ½" wrenches disconnect BLACK battery cable then RED battery cable.

3.Position deck to lowest setting.

4.Front underside of frame, remove the nuts that secure the battery hold-down.

5.Carefully remove the battery from the mower.

6.Install new battery with terminals in the same position as the old battery.

7.Reinstall battery hold-down and secure with nuts removed in Step 4.

8.Reconnect RED battery cable to positive (+) battery terminal with bolt and hex nut.

9.Connect BLACK grounding cable to negative (-) battery terminal with remaining hex bolt and hex nut

10.Replace terminal boot cover.

11.Lower seat

STANDARD	STATE	APPROXIMATE BATTERY CHARGING TIME*
		TO FULL CHARGE AT 80OF / 27OC
BATTERY	OF
			Maximum Rate at:
	CHARGE
		50 Amps	30 Amps	20 Amps	10 Amps
12.6V	100%	- FULL CHARGE -
12.4V	75%	20 min.	35 min.	48 min.	90 min.
12.2V	50%	45 min.	75 min.	95 min.	180 min.
12.0V	25%	65 min.	115 min.	145 min.	280 min.
11.8V	0%	85 min.	150 min.	195 min.	370 min.

*Charging time depends on battery capacity,

condition, age, temperature and efficiency of charger

IMPORTANT INFORMATION

Do not attempt to open or remove caps or covers. Adding or checking level of electrolyte is not necessary.

Always use two wrenches for the terminal screws.

WARNING!

Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparks from accidental grounding.

8050-109

Remove battery hold-down to replace battery

40