Husqvarna LZ6127TKOA manual Setup And Adjustments, Control Arms, Seat Install, Engine Oil, Fig

SETUP AND ADJUSTMENTS

Control Arms

Remove top bolt in control arm and loosen bot- tom bolt, rotate the control levers to the upright position. Align the levers so they are even in the neutral position. Reinstall hardware and tighten. FIG - 1

Seat Install

1.Remove seat assembly from the crate.

2.Remove the four 5/16C nyloc nuts or 5/16C studed knobs from the bottom of the seat. Retain for use later.

3.Align the seat bottom with the holes in the seat frame. Place seat on top of the seat frame and secure with the four nuts or knobs re- moved in step 2.

4.Connect the wire harness from the seat to the frame harness.

Engine Oil

Check engine oil with dip stick. Add if needed per the engine manufactures specifications. See en- gine manual for oil type and filling specifications. FIG - 2

Loosen the discharge chute slightly and lower into position. Chute should be snug but still pivot freely.

Adjustments

Cutting Height

Stop the mower and disengage the blades.

Raise the deck height lever to the transport posi- tion.

Remove the height adjustment pin and place it in the desired cutting height hole. Lower the lift lever down onto pin. NOTE: Anti-scalp rollers must be in the proper position for maximum deck floata- tion. See the decal on the front deck for proper settings. FIG - 5

Control	Motion
Arm	Control
	Lever

FIG - 1

“F” Full

Operating Mark

Range

FIG - 2

Lift Lever

Deck Height

Adjustment

Plates

FIG - 3

16