HOW TO SEW BUTTONHOLES
Preparation
Select buttonhole with the stitch Selection dial. Snap on The buttonhole foot.
Adjust the stitch length dial between “0.5” - “1”.
The density of the stitch depends on thickness of the fabric.
Note: Always test sew a buttonhole.
To prepare the fabric
Measure the diameter of the button and add 0.3 cm (1/8”) for the bartacks. If you have a very thick button, add more to the diameter measurement. Mark the position and length of the buttonhole on the fabric. Position the fabric so that the needle is on the mark that is furthest from you. Pull the buttonhole foot towards you as far as it will go.
Lower the foot.
1.Select buttonhole with the stitch selection dial. Turn the stitch selection dial to (1) “ 
“. Sew at moderate speed until you reach the end mark.
2.Turn the stitch selection dial to (2, 4)“ 
“ and sew
3.Turn the stitch selection dial to (3) “ 
“ and sew the left side of the buttonhole to the mark at the end which is further from you.
4.Turn the stitch selection dial to (2, 4) “ 
“ and sew bar tack stitches.
Remove the fabric from under the foot. Pull the upper thread to the wrong side of the fabric and knot upper and lower threads. Cut the center of the buttonhole with the seam ripper, being careful not to cut the stitches on either side.
Stitch length dial
23
