![](/images/new-backgrounds/1228815/22881591x1.webp)
FIGURE 2 | FIGURE 3 |
|
|
|
|
2A. BLADE SHAFT BOLT: Use to clamp the diamond blade between the inner and outer flange. Right side of saw has left hand threads. Left side of saw has right hand threads.
2B. OUTER FLANGE: Use to hold the diamond blade in position.
2C. OUTER FLANGE ARBOR: Use to support the diamond blade.
2D. LOCKING PIN: Use to prevent the diamond blade from rotating on the shaft during operation.
2E. DIAMOND BLADE: Use as the cutting tool for concrete and asphalt surfaces.
2F. INNER FLANGE: Inside support used to hold the diamond blade in position.
2G. BLADE GUARD NOSE LATCH: Use to latch the front part of blade guard down.
2H. BLADE GUARD FRONT: The front part of the blade guard.
2I. BLADESHAFT: Supports Blade Flanges and
3A. ENGINE GEARBOX:
3B. WATER CONNECTION: Circulates freshwater through gearbox to cool it. Water then flows to the bladeguard.
3C. WATER DRAIN VALVE: Twist and push up to drain water from gearbox. Drain daily to prevent corro- sion or damage due to freezing temperatures.
3D. BELT GUARDS: Remove to install new
3E. FLANGE COVER:
3F. BELT PROTECTOR SHIELD: Keep in place.
3G. BLADESHAFT TUBE ASSY: Sealed unit contains bladeshaft, bearings and shaft seals.
3H. TIEDOWN LUGS: Used to tie the saw down while transporting by vehicle. Not to be used to lift the saw.
3I. ENGINE OIL DRAIN VALVE: Drains engine oil without use of tools.
3J. BELT TENSIONING BOLTS:
3K. HORIZONTAL CLAMPING BOLTS:
3L. BLADE SHAFT PULLEY:
3M.
3N. GEARBOX PULLEY:
46