ASSEMBLY
Use terminal access doors for:
•Inspection for secure connections (to tighten hard- ware).
•Inspection for corrosion.
•Testing battery.
•Jumping (if required).
•Periodic charging.
HEX NUT | LOCK | FLAT |
DISCARD | WASHER | WASHER |
TERMINAL |
|
|
PROTECTIVE |
| HEX |
CAPS |
| |
| BOLT | |
|
|
TO ATTACH NOSE ROLLER (See Fig. 4)
•Position brackets, washers and nose roller between deck mounting brackets as shown. Be sure to position brackets on correct side, as shown.
•Install hex bolts and locknuts as shown. Tighten hardware securely.
NOTE: Be sure tabs brackets are positioned in tab holes in deck brackets.
"B" BRACKET TAB |
TAB HOLE |
NOSE ROLLER |
HEX |
BOLT |
TERMINAL
ACCESS
DOOR
VENT HOLE 
(KEEP CLEAN)
POSITIVE (RED)
CABLE
NEGATIVE (BLACK)
CABLE
"A" | LOCKNUT | |
| ||
BRACKET | WASHER | |
TAB | ||
|
FIG. 4
CHECK TIRE PRESSURE
The tires on your tractor were overinflated at the factory for shipping purposes. Correct tire pressure is important for best cutting performance.
FIG. 2
INSTALL SEAT (See Fig. 3)
Adjust seat before tightening adjustment knob.
•Remove cardboard packing on seat pan.
•Place seat on seat pan and assemble shoulder bolt.
•Assemble adjustment knob and flat washer loosely. Do not tighten.
•Tighten shoulder bolt securely.
•Lower seat into operating position and sit on seat.
•Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.
•Get off seat without moving its adjusted position.
•Raise seat and tighten adjustment knob securely.
SEAT
SEAT PAN
SHOULDER
BOLT
FLAT
WASHER
ADJUSTMENT KNOB
FIG. 3
•Reduce tire pressure to PSI shown in “PRODUCT SPECIFICATIONS” on page 3 of this manual.
CHECK BRAKE SYSTEM
After you learn how to operate your tractor, check to see that the brake is properly adjusted. See “TO ADJUST BRAKE” in the Service and Adjustments section of this manual.
7
