To Replace Headlight Bulb, Interlocks and Relays | Husqvarna GTH220

SERVICE AND ADJUSTMENTS

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section of this manual.

TO REPLACE FUSE

Replace with 30 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO ADJUST ATTACHMENT LIFT SPRING (See Fig. 34)

•While holding spring bushing with wrench, loosen jam nut.

•Turn adjustment bolt clockwise to extend spring and reduce lift effort for heavier attachments.

•Turn adjustment bolt counterclockwise for lighter at- tachments.

•Retighten jam nut against spring bushing.

IMPORTANT: DO NOT ADJUST FOR MAXIMUM SPRING TENSION WHEN USING LIGHT ATTACHMENTS SUCH AS A MOWER. ADJUST LIFT LEVER SPRING TO AID IN LIFTING ATTACHMENT. DO NOT OVERPOWER SPRING. WHEN REMOVING ATTACHMENT, ALWAYS ADJUST SPRING TENSION TO ITS LOWEST POSITION.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 35)

•Lift hood. Disconnect headlight wire connection.

•Remove wing nuts on inside of side panels.

•Pivot hood and side panel forward and lift off tractor.

•To replace, reverse above procedure.

ADJUSTMENT	SPRING BUSHING
BOLT

	ATTACHMENT
JAM NUT	LIFT SPRING
JAM NUT

FIG. 34

WINGNUT (INSIDE)

WIRE CONNECTION

FIG. 35

26

Image 26

Husqvarna GTH220 owner manual To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse

Contents

GTH220 Safety Rules Safe Operation Practices for Ride-On Mowers Model Number GTH220 Serial Product SpecificationsCustomer Responsibilities Table of Contents Contents of Hardware Pack To Remove Tractor from Carton AssemblyTools Required for Assembly Before Rolling Tractor OFF Skid Check Tire Pressure Install Seat See FigTo Attach Nose Roller See Fig Check Brake System Check for Proper Position of ALL Belts Install Mower and Drive Belt See FigsCheck Deck Levelness Checklist To Attach Front Bumper See Fig Lock Locked Reverse Neutral High LOW OperationUnlocked Height Adjustment Knob Used to adjust the mower height Know Your Tractor HOW to USE Your Tractor To Operate on Hills To Adjust Gauge Wheels See FigTo Operate Mower See Figs To Transport See Figs Check Engine OIL Level See Fig Indicator LightsBefore Starting the Engine ADD Gasoline Mowing Tips Purge Transmission General Recommendations Lubrication ChartCustomer Responsibilities Before Each USE Brake Operation BatteryTractor Tires Transaxle Pump Fluid EngineTransaxle Cooling Belts Engine OIL Filter CleaningClean AIR INTAKE/COOLING Areas Muffler To Level Mower Housing Service and AdjustmentsTo Install Mower To Remove Mower See Fig FRONT-TO-BACK Adjustment See Figs To Replace Mower Drive Belt To Adjust Attachment Clutch See Fig To Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See Fig To Adjust Brake See FigBelt Installation Belt Removal To Adjust Steering Wheel Alignment To Adjust Motion Control Lever See FigTransmission REMOVAL/REPLACEMENT Front Wheel TOE-IN Adjustment To Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigFront Wheel Camber To Attach Jumper Cables To Replace Headlight Bulb To Adjust Attachment Lift Spring See FigTo Remove Hood and Grill Assembly See Fig Interlocks and Relays To Adjust Throttle Control Cable See Fig To Adjust Choke Control See Figs Final Setting To Adjust Carburetor See FigPreliminary Setting Acceleration Test Fuel System StorageOther Engine OIL Troubleshooting Points Problem Cause Correction OFF Service Notes Schematic Tractor Model NO. GTH220 954830167A Repair Parts Electrical KEY Part NO. NO. Description 47120 Chassis and Enclosures KEY Part Description Ground Drive Repair Parts Steering Assembly 532124415 Wheel, Steering 532137094 Engine KEY Part NO. NO. Description Seat Assembly GBD48 DecalsWheels & Tires GSB42 Lift Assembly Nut, Special Mower Deck KEY Part Description Transaxle Hydro Gear Model Number AYP Description Transaxle PUMP- Model Number BDU-10L-118 Service Notes Sighting Guide CUT This OUT Dotted Is a Slope Warranty Statement Limited Warranty 532150629 08.17.95 Kfsw