Husqvarna GTH2350 Cleaning, AIR FILTER See Fig, Engine Oil Filter, Muffler, Spark Plugs

Models: GTH2350

1 48
Download 48 pages 40 Kb
Page 19
Image 19
AIR FILTER (See Fig. 15)

CUSTOMER RESPONSIBILITIES

NOTE: Operating the engine with a blocked grass screen, dirty or plugged cooling fins, and/or cooling shrouds removed will cause engine damage due to overheating.

AIR FILTER (See Fig. 15)

Your engine will not run properly using a dirty air filter. Clean the foam pre-cleaner after every 25 hours of operation or every season. Service paper cartridge every 100 hours of operation or every season, whichever occurs first.

Service air cleaner more often under dusty conditions.

Loosen knob and remove cover.

TO SERVICE PRE-CLEANER

Slide foam pre-cleaner off cartridge.

Wash it in liquid detergent and water.

Squeeze it dry in a clean cloth. Allow it to dry.

Saturate it in engine oil. Wrap it in clean, absorbent cloth and squeeze to remove excess oil.

TO SERVICE CARTRIDGE

Replace a dirty, bent, or damaged cartridge.

NOTE: Do not wash the paper cartridge or use pressurized air, as this will damage the cartridge.

Remove nut and cartridge plate.

Reinstall the pre-cleaner (cleaned and oiled) over the paper cartridge.

Check rubber seal for damage and proper position around stud. Replace if necessary.

Reassemble air cleaner, cartridge plate, and nut.

Reinstall air cleaner cover and secure by tightening knob.

CARTRIDGE

 

FOAM

 

 

PRE-CLEANER

 

 

CARTRIDGE

 

 

PLATE

RUBBER

 

 

KNOB

 

SEAL

NUT

FIG. 15

ENGINE OIL FILTER

Replace the engine oil filter every season or every other oil change if the tractor is used more than 100 hours in one year.

MUFFLER

Inspect and replace corroded muffler and spark arrester (if equipped) as it could create a fire hazard and/or damage.

SPARK PLUGS

Replace spark plugs at the beginning of each mowing season or after every 100 hours of operation, whichever occurs first. Spark plug type and gap setting are shown in “PRODUCT SPECIFICATIONS” section of this manual.

IN-LINE FUEL FILTER (See Fig. 16)

The fuel filter should be replaced once each season. If fuel filter becomes clogged, obstructing fuel flow to carburetor, replacement is required.

With engine cool, remove filter and plug fuel line sec- tions.

Place new fuel filter in position in fuel line with arrow pointing towards carburetor.

Be sure there are no fuel line leaks and clamps are properly positioned.

Immediately wipe up any spilled gasoline.

CLAMP

CLAMP

FUEL FILTER

FIG. 16

CLEANING

Clean engine, battery, seat, finish, etc. of all foreign matter.

Keep finished surfaces and wheels free of all gasoline, oil, etc.

Protect painted surfaces with automotive type wax.

We do not recommend using a garden hose to clean your tractor unless the electrical system, muffler, air filter and carburetor are covered to keep water out. Water in engine can result in a shortened engine life.

19

Page 19
Image 19
Husqvarna GTH2350 Cleaning, AIR FILTER See Fig, Engine Oil Filter, Muffler, Spark Plugs, IN-LINEFUEL FILTER See Fig