OPERATION
•For best cutting performance, grass over 6 inches in height should be mowed twice. Make the first cut relatively high; the second to desired height.
TO ADJUST GAUGE WHEELS (See Fig. 8)
Gauge wheels are properly adjusted when they are slightly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in proper position to help prevent scalping in most terrain conditions.
NOTE:Adjust gauge wheels with tractor on a flat level surface.
•Adjust mower to desired cutting height.
•Lower mower with lift control. Remove rear retainer spring and clevis pin which secure each gauge wheel.
•Lower gauge wheels to ground. Raise gauge wheels slightly to align holes in bracket and gauge wheel bar and insert clevis pins. Gauge wheels should be slightly off the ground.
•Replace retainer springs into clevis pins.
ATTACHMENT | LIFT LEVER |
CLUTCH SWITCH | HIGEST |
PULL OUT TO | POSITION |
“ENGAGE” |
|
| LOWEST |
| POSITION |
| DEFLECTOR |
PUSH IN TO | SHIELD |
| |
“DISENGAGE” |
|
FIG. 9
TO OPERATE ON HILLS
CAUTION: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope.
• | Choose the slowest speed before starting up or down |
| hills. |
• | Avoid stopping or changing speed on hills. |
RETAINER
SPRING
GAUGE
WHEEL
BAR
GAUGE
WHEEL
CLEVIS PIN
• If stopping is absolutely necessary, push brake pedal |
quickly to brake position and engage parking brake. |
IMPORTANT: T H E M O T I O N C O N T R O L L E V E R RETURNS TO NEUTRAL (N) POSITION WHEN THE BRAKE PEDAL IS FULLY DEPRESSED.
•To restart movement, slowly release parking brake and brake pedal.
•Slowly move motion control lever to slowest setting.
•Make all turns slowly.
TO TRANSPORT (See Figs. 6 and 10)
When pushing or towing your tractor, be sure to disengage
BRACKET
FIG. 8
TO OPERATE MOWER (See Fig. 9)
Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine.
•Select desired height of cut.
•Lower mower with attachment lift control.
•Start mower blades by engaging attachment clutch control.
•TO STOP MOWER BLADES - disengage attachment clutch control.
CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector shield in place.
transmission by placing freewheel control in freewheeling position. Free wheel control is located at the rear drawbar of tractor.
•Raise attachment lift to highest position with attachment lift control.
•Pull freewheel control out and into the slot and release so it is held in the disengaged position.
•Do not push or tow tractor at more than two (2) MPH.
•To reengage transmission, reverse above procedure.
NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).
13 | FIG. 10 |
