Husqvarna GTH2350 owner manual INSTALL MOWER AND DRIVE BELT See Figs. 5 and, Assembly

ASSEMBLY

INSTALL MOWER AND DRIVE BELT (See Figs. 5 and 6)

Be sure tractor is on level surface and mower suspension arms are raised with attachment lift control. Engage parking brake.

•Cut and remove ties securing anti-sway bar and belts. Swing anti-sway bar to left side of mower deck.

•Slide mower under tractor with deflector shield to right side of tractor.

IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES.

•If equipped, turn height adjustment knob counterclock- wise until it stops.

•Lower mower linkage with attachment lift control.

•Install belt into electric clutch pulley groove.

•Place the suspension arms on inward pointing deck pins. Retain with double loop retainer spring with loops down as shown.

•Install front plate assembly to tractor suspension brack- ets and retain with single loop retainer springs as shown.

retainer springs between the plate and mower brackets.

NOTE: To assist in locating hole in flanged pin, the hole in pin is inline with notch on head of pin. If necessary, move mower side-to-side to give space between plate and mower brackets.

IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES.

•Connect anti-sway bar to chassis bracket under left footrest and retain with double loop retainer spring.

•If equipped, turn height adjustment knob clockwise to remove slack from mower suspension.

•Raise deck to highest position.

•Assemble gauge wheels as shown using long shoulder bolts, 3/8 washers, and 3/8-16 center locknuts. Tighten securely.

•Adjust gauge wheels before operating mower as shown in the Operation section of this manual.

•Position front plate assembly between front mower brackets. Raise deck and plate assembly to align holes and insert flanged pins. Secure pins with double loop

		CHASSIS
	DOUBLE LOOP	BRACKET
		SUSPENSION
	RETAINER
		ARMS
	SPRING
SHOULDER		IDLER
	GAUGE	PULLEY
BOLT
	WHEEL

FRONT SUSPENSION

BRACKETS

	ELECTRIC CLUTCH
	PULLEY
FRONT
MOWER
BRACKET	FRONT PLATE
	ASSEMBLY

3/8

WASHER

3/8-16 DOUBLE

CENTER LOOP

LOCKNUT RETAINER SPRING

USE PLIERS FOR

RETAINER SPRINGS

SINGLE

LOOP RETAINER

SPRINGS

ANTI-SWAY
BAR	DEFLECTOR
	SHIELD

DOUBLE LOOP RETAINER SPRING (INWARD POINTING DECK PINS)

LOOP

DOWN

FIG. 5

8