Husqvarna HUV 4213-GXP owner manual Controls And Indicators

Controls and Indicators

47

Figure 3 Serial Number

CONTROLS AND INDICATORS

See General Warnings on page 9.

WARNING

•Before allowing anyone to drive the vehicle, make sure the driver is familiar with all controls and operating procedures.

•Do not tamper with the governor. Doing so will void the warranty, as well as damage the engine and other components, and could result in property damage, personal injury, or death due to unsafe speeds.

•Do not shift the Forward/Reverse handle while the vehicle is in motion.

•Engine must be at idle before shifting the Forward/Reverse handle. Failure to do so may result in injury to inattentive passengers and (or) damage to the vehicle.

•To avoid injury to an inattentive passenger or damage to the vehicle, always bring the vehicle to a full stop before shifting the Forward/Reverse handle.

•To avoid unintentionally starting or rolling the vehicle, set the park brake, place the Forward/Reverse handle in the NEUTRAL position, turn the key switch to the OFF position, and remove the key when leaving the vehicle.

•With the differential lock engaged, vehicle turning functions are greatly reduced. To prevent loss of vehicle control when differential lock is engaged, do not operate vehicle at speeds greater than half throttle and use caution when attempting to turn the vehicle.

2008 HUV 4213-G and HUV 4213-GXP Owner’s Manual Page 11