Seat Latch and Adjustment

164

Figure 11 Low Oil Warning Light

FUEL GAUGE/HOUR METER

A fuel gauge and hour meter are housed together at the lower left corner of the instrument panel. The fuel gauge operates when the key switch is in the ON position, and allows the operator to monitor the fuel level in the vehicle. The hour meter operates only when the engine is running, and should be used only by trained technicians to track vehicle usage and determine when periodic service procedures are required. See Periodic Service Schedule on page 27.

HEADLIGHT CONTROL

The headlight control is located on the front instrument panel between the fuel gauge/hour meter and steering column. Pull the headlight control knob out to turn the headlights on and push the knob in to turn the headlights off.

NOTE: Using the headlights for extended periods of time without the engine running, or with the engine idling, will discharge the battery.

LIGHT BAR CONTROL

The light bar control is a toggle switch located on the instrument panel above and slightly left of the headlight control knob. Place the toggle switch in the upper position to illuminate the light bar lights and in the lower position to turn the light bar lights off.

SEAT LATCH AND ADJUSTMENT

The seats are hinged to allow easy access to the engine compartment. A latch at the rear of each seat bottom keeps the seat from moving on its hinges while the vehicle is in operation. To disengage the latch, grasp the seat back and pull firmly in a forward/upward direction until the latch releases. To engage the seat latch, push down firmly on the seat back until the seat locks into place. See following WARNING.

Page 16 2008 HUV 4213-G and HUV 4213-GXP Owner’s Manual

Page 18
Image 18
Husqvarna HUV 4213-GXP Seat Latch and Adjustment, Fuel GAUGE/HOUR Meter, Headlight Control, Light BAR Control