Husqvarna HUV 4213-GXP owner manual Maintenance

Maintenance

4.1.Remove plug from fuel tank vent.

4.2.Connect vent tube to fuel tank vent.

5.Connect battery cables, positive (+) cable first, and tighten terminals to 144 in-lb (16 N·m). Coat terminals with Battery Terminal Protector Spray (P/N 603 00 00-03).

6.Completely open the fuel shut-off valve (Figure 14). Make sure the valve is fully open. A partially closed fuel shut-off valve combined with the use of the choke can result in a fouled spark plug and engine failure.

7.Place the Forward/Reverse handle in the NEUTRAL position. Crank the engine until fuel is pumped into the carburetor and fuel lines and the engine starts. Turn the engine off. See following NOTE.

NOTE: Due to the oil added to the engine in preparation for storage, engine may smoke excessively for a short time when it is run for the first time after storage.

8.Lower the passenger side seat and lower the cargo bed.

9.Adjust tires to recommended tire pressure. See Vehicle Specifications on page 40.

10. Perform the Pre-Operation and Daily Safety Checklist on page 17.

MAINTENANCE

See General Warnings on page 9.

To ensure trouble-free vehicle performance, follow an established preventive maintenance program. Regular maintenance can prevent vehicle downtime and expensive repairs that result from neglect. Use the Pre-Operation and Daily Safety Checklist on page 17and the following Periodic Service Schedule and Periodic Lubrication Schedule to keep the vehicle in proper working condition.

Any vehicle not functioning correctly should not be used until it is repaired. This will prevent further damage to the vehicle and avoid the possibility of injury due to unsafe conditions.

Contact your local Husqvarna dealer for repairs, semiannual and annual periodic service.

WARNING

•Only trained technicians should service or repair the vehicle. Anyone doing even simple repairs or service should have knowledge and experience in electrical and mechanical repair. The appropriate instructions must be used when performing maintenance, service, or accessory installation.

•If any problems are found during scheduled inspection or service, do not operate vehicle until repairs are made. Failure to make necessary repairs could result in fire, property damage, severe personal injury, or death.

•Do not wear loose clothing or jewelry, such as rings, watches, chains, etc., when servicing vehicle.

•Turn the key switch to the OFF position, remove the key, place the Forward/Reverse handle in the NEUTRAL position, and chock the wheels prior to servicing the vehicle.

•Moving parts: Do not attempt to service vehicle while engine is running.

•Hot! Do not attempt to service hot engine or exhaust system. Failure to heed this warning could result in severe burns.

•For vehicles with cargo beds, remove all cargo before raising the bed or servicing the vehicle. If the vehicle is equipped with a prop rod, ensure that it is securely engaged. Do not close bed until all persons are clear of cargo bed area. Keep hands clear of all crush areas. Do not drop cargo bed; lower gently and keep entire body clear. Failure to heed this warning could result in severe personal injury or death.

•Do not work on vehicle powertrain or under cargo bed when it is loaded.

•Turn the fuel shut-off valve to the closed (OFF) position (Figure 14).

WARNING CONTINUED ON NEXT PAGE

Page 26 2008 HUV 4213-G and HUV 4213-GXP Owner’s Manual