Husqvarna HUV 4213-GXP Returning The Stored Vehicle To Service, General Warnings on page

Storage

7.Disconnect the battery cables, negative (–) cable first. See WARNING “To avoid unintentionally starting...” in

General Warnings on page 9.

8.Batteries should be clean and free of corrosion. Wash tops and terminals of batteries with a solution of baking soda and water (1 cup (237 mL) baking soda per 1 gallon (3.8 L) of water). Rinse solution off batteries. Do not allow this solution to enter the batteries. Be sure terminals are tight. Let the terminals dry and then coat them with Battery Terminal Protector Spray (P/N 603 00 00-03).

3

1

2

1.Fuel Shut-off Valve

2.Closed (OFF)

3.Open (ON)

NOTE: When selecting valve position, ensure that it is fully opened or fully closed.

449

Figure 14 Fuel Shut-off Valve

9.To protect the engine, remove spark plug and pour 1/2 ounce (14.2 mL) of SAE 10 weight oil into the engine through the spark plug hole. Rotate engine crankshaft by hand several times and then install the spark plug and tighten to 20 ft-lb (27 N·m).

10.Lower the passenger side seat and lower the cargo bed.

11.Adjust tires to recommended tire pressure. See Vehicle Specifications on page 40.

12.Perform semiannual periodic lubrication. See Periodic Lubrication Schedule on page 29.

13.Thoroughly clean front body, rear body, seats, cargo bed, engine compartment, and underside of vehicle.

14.Do not engage the park brake. Chock the wheels to prevent the vehicle from rolling.

RETURNING THE STORED VEHICLE TO SERVICE

1.Make sure the key switch is in the OFF position and the Forward/Reverse handle is in the NEUTRAL position. Chock the wheels.

2.Raise the cargo bed to access the engine and battery. See WARNING “For vehicles with cargo beds...” in

General Warnings on page 9.

3.Lift the front passenger seat.

4.Restore fuel system to operation (Figure 24).

2008 HUV 4213-G and HUV 4213-GXP Owner’s Manual Page 25