Engine Oil
WARNING
•For vehicles with cargo beds, remove all cargo before raising the bed or servicing the vehicle. If the vehicle is equipped with a prop rod, ensure that it is securely engaged while bed is raised. Do not close the bed until all persons are clear of cargo bed area. Keep hands clear of all crush areas. Do not drop cargo bed; lower gently and keep entire body clear. Failure to heed this warning could result in severe personal injury or death.
3.Disconnect the battery cables, negative
General Warnings on page 9.
4.Position a pan designed for oil changes under the front drain plug (Figure 18).
5.Use a 14 mm socket or wrench to remove the drain plug, turning it counterclockwise, and allow the engine oil to drain into the pan.
WARNING
•Do not attempt to change engine oil when the engine is hot or even warm. Engine oil can cause skin burns.
•Wear safety glasses or approved eye protection when servicing the vehicle. Wear rubber gloves when handling oil drain plug, oil filter, and oil drain pan.
6.Clean the oil drain plug threads with solvent to remove oil and oil residue. Make sure that the compression washer remains on the drain plug.
7.Use a 14 mm socket or wrench and replace the front oil drain plug, turning it clockwise, and tighten to 18
1. Drain pan 2. Drain plug 3. Oil filter
25
Figure 18 Engine Oil Drain Plug and Pan
8.Place a floor jack under the rear receiver hitch where the hitch and body frame are fastened. Lift the vehicle body slightly, allowing the front of the engine to tilt slightly downward. This will allow the oil filter more clearance under the electrical component box (Figure 19).
9.Relocate the oil drain pan to a position under the engine oil filter (Figure 20).
Page 32 2008 HUV
